By jerry 1 rating This is a Water Balloon Canon I made myself with what I basically had around the house. And it wasn’t too hard

This is a water balloon canon I made myself with what I basically had around the house. And it wasn’t too hard

            Fore the pressure chamber I used 3” PVC pipe with fittings so I could attach a pressure gage an attachment for a compressor to hock up to it and a safety pressure release gage for safety pressure gage on the tank to release pressure if it gets above 95 PSI at the end of the tank I have a 1” sprinkler valve hooked up to a switch to automatically shot it. I fill my tank using only air pressure from a air compressor, and you cant pressurize it to above 40 PSI or it will blow up the balloon for sure it’s moor advisable to keep it about 30-35 PSI. I mounted it on a wooden stand on a cart so I could move it more easily, and hold it easier and fire it easier. I just did a total re hall on the stand so it can tilt and go to different angels and it’s much easier to use.

PS. the photos on the side aren’t updated their old it doesn’t look like that exactly.